Found 10000 publications. Showing page 337 of 400:
Polluted air is a major global health risk factor, yet the chemical composition and toxicity of airborne gases and particles remain underexplored due to their complexity and difficulties in sampling. We recently introduced how polydimethylsiloxane (PDMS) foam─or silicone foam─can be synthesized for passive air sampling, enabling simple and cost-effective nontarget chemical profiling of indoor air. Here, we demonstrate expanded applications, indoors and outdoors, with commercial PDMS-foam, including for: (i) wide-scope target analysis of >220 priority substances by quantitative liquid- and gas chromatography-high-resolution mass spectrometry, (ii) microscopic characterization and nontarget profiling of accumulated fine particles, and (iii) effect-guided discovery of harmful substances, combining toxicological data with nontarget analysis in silico. Median method quantification limits were 0.12 ng/mL, 90% of target analytes had absolute recoveries between 70 and 130%, and hazardous substances were discovered, including ethylene glycols, insecticides, and UV filters. Microscopy revealed the accumulation of abundant fine particles, and the automated characterization of the fluorescent fraction revealed that most were <4 μm. Extracts from outdoor samples reduced human lung cell viability, and multivariate modeling flagged families of potentially toxic substances in a virtual effect-directed analysis. PDMS-foam disks require field calibration to determine their linear sampling rate(s), but current results and applications establish PDMS-foam as a multimodal passive sampler, enabling integrated chemical quantitation, toxicological analysis, and molecular discovery in air.
2026
2012
Simplified models for integrated air quality management in urban areas. NATO science for peace and security series
2008
Interdecadal change in the relationship between the East Asian winter monsoon (EAWM) and the Arctic Oscillation (AO) has been documented by many studies. This study, utilizing the model outputs from phase 5 of the Coupled Model Intercomparison Project (CMIP5), evaluates the ability of the coupled models in CMIP5 to capture the intensified relationship between the EAWM and winter AO since the 1980s, and further projects the evolution of the EAWM–AO relationship during the 21st century. It is found that the observed evolution of the EAWM–AO relationship can be reproduced well by some coupled models (e.g., GFDL-ESM2M, GISS-E2-H, and MPI-ESM-MR). The coupled models’ simulations indicate that the impact of winter AO on the EAWM-related circulation and East Asian winter temperature has strengthened since the 1980s. Such interdecadal change in the EAWM–AO relationship is attributed to the intensified propagation of stationary planetary waves associated with winter AO. Projections under the RCP4.5 and RCP8.5 scenarios suggest that the EAWM–AO relationship is significant before the 2030s and after the early 2070s, and insignificant during the 2060s, but uncertain from the 2030s to the 2050s.
2018
2005
Simulating CH4 and CO2 over South and East Asia using the zoomed chemistry transport model LMDz-INCA
The increasing availability of atmospheric measurements of greenhouse gases (GHGs) from surface stations can improve the retrieval of their fluxes at higher spatial and temporal resolutions by inversions, provided that transport models are able to properly represent the variability of concentrations observed at different stations. South and East Asia (SEA; the study area in this paper including the regions of South Asia and East Asia) is a region with large and very uncertain emissions of carbon dioxide (CO2) and methane (CH4), the most potent anthropogenic GHGs. Monitoring networks have expanded greatly during the past decade in this region, which should contribute to reducing uncertainties in estimates of regional GHG budgets. In this study, we simulate concentrations of CH4 and CO2 using zoomed versions (abbreviated as "ZAs") of the global chemistry transport model LMDz-INCA, which have fine horizontal resolutions of ∼ 0.66° in longitude and ∼ 0.51° in latitude over SEA and coarser resolutions elsewhere. The concentrations of CH4 and CO2 simulated from ZAs are compared to those from the same model but with standard model grids of 2.50° in longitude and 1.27° in latitude (abbreviated as "STs"), both prescribed with the same natural and anthropogenic fluxes. Model performance is evaluated for each model version at multi-annual, seasonal, synoptic and diurnal scales, against a unique observation dataset including 39 global and regional stations over SEA and around the world. Results show that ZAs improve the overall representation of CH4 annual gradients between stations in SEA, with reduction of RMSE by 16–20% compared to STs. The model improvement mainly results from reduction in representation error at finer horizontal resolutions and thus better characterization of the CH4 concentration gradients related to scattered distributed emission sources. However, the performance of ZAs at a specific station as compared to STs is more sensitive to errors in meteorological forcings and surface fluxes, especially when short-term variabilities or stations close to source regions are examined. This highlights the importance of accurate a priori CH4 surface fluxes in high-resolution transport modeling and inverse studies, particularly regarding locations and magnitudes of emission hotspots. Model performance for CO2 suggests that the CO2 surface fluxes have not been prescribed with sufficient accuracy and resolution, especially the spatiotemporally varying carbon exchange between land surface and atmosphere. In addition, the representation of the CH4 and CO2 short-term variabilities is also limited by model's ability to simulate boundary layer mixing and mesoscale transport in complex terrains, emphasizing the need to improve sub-grid physical parameterizations in addition to refinement of model resolutions.
2018
2003
2014
2003
2009
2013
2002
2001
Simulation of volcanic ash ingestion into a large aero engine: particle–fan interactions
Volcanic ash (VA) clouds in flight corridors present a significant threat to aircraft operations
as VA particles can cause damage to gas turbine engine components that lead to a
reduction of engine performance and compromise flight safety. In the last decade,
research has mainly focused on processes such as erosion of compressor blades and
static components caused by impinging ash particles as well as clogging and/or corrosion
effects of soft or molten ash particles on hot section turbine airfoils and components.
However, there is a lack of information on how the fan separates ingested VA particles
from the core stream flow into the bypass flow and therefore influences the mass concentration
inside the engine core section, which is most vulnerable and critical for safety. In
this numerical simulation study, we investigated the VA particle–fan interactions and
resulting reductions in particle mass concentrations entering the engine core section as a
function of particle size, fan rotation rate, and for two different flight altitudes. For this,
we used a high-bypass gas-turbine engine design, with representative intake, fan, spinner,
and splitter geometries for numerical computational fluid dynamics (CFD) simulations
including a Lagrangian particle-tracking algorithm. Our results reveal that
particle–fan interactions redirect particles from the core stream flow into the bypass
stream tube, which leads to a significant particle mass concentration reduction inside the
engine core section. The results also show that the particle–fan interactions increase
with increasing fan rotation rates and VA particle size. Depending on ingested VA size
distributions, the particle mass inside the engine core flow can be up to 30% reduced
compared to the incoming particle mass flow. The presented results enable future calculations
of effective core flow exposure or dosages based on simulated or observed atmospheric
VA particle size distribution, which is required to quantify engine failure
mechanisms after exposure to VA. As an example, we applied our methodology to a
recent aircraft encounter during the Mt. Kelud 2014 eruption. Based on ambient VA concentrations
simulated with an atmospheric particle dispersion model (FLEXPART), we
calculated the effective particle mass concentration inside the core stream flow along the
actual flight track and compared it with the whole engine exposure.
2019