Found 10483 publications. Showing page 321 of 420:
2020
2020
Health Risk Assessment of Air Pollution in Europe. Methodology description and 2017 results
This report describes the methodology applied to assess health risks across Europe in 2016, published in the European Environmental Agency’s Air Quality in Europe – 2019 report. The methodology applied is based on the work by de Leeuw and Horálek (2016), with a few adjustments. To estimate the health risk related to air pollution, the number of premature deaths and years of life lost related to exposure to fine particulate matter, ozone and nitrogen dioxide exposure were calculated for 41 countries across Europe. The results show that the largest health risks are estimated for the countries with the largest populations. However, in relative terms, when considering e.g., years of life lost per 100 000 inhabitants, the largest relative risks are observed in central and eastern European countries, and the lowest are found for the northern and north-western parts of Europe. Additionally to the assessment, a sensitivity analysis was undertaken to comprehend how much the presumed baseline concentration levels, the concentration below which no health effects are expected, affect the estimations. In addition, a benefit analysis, assuming attainment of the PM2.5 WHO guidelines across Europe, shows a reduction over 30 % of the 2017 premature deaths and years of life lost numbers.
ETC/ATNI
2020
Even though production and open use of polychlorinated biphenyls (PCBs) have been phased out in Western industrialised countries since the 1980s, PCBs were still present in waste collected from different waste handling facilities in Norway in 2013. Sums of seven indicator-PCBs (I-PCB7: PCB-28, -52, -101, -118, -138, -153 and -180) were highest in plastic waste (3700 ±1800 μg/kg, n=15), waste electrical and electronic equipment (WEEE) (1300 ± 400 μg/kg, n=12) and fine vehicle fluff (1800 ± 1400 μg/kg, n=4) and lowest in glass waste, combustibles, bottom ash and fly ash (0.3 to 65 μg/kg). Concentrations in leachate water varied from 1.7 to 2900 ng/L, with higher concentrations found at vehicle and WEEE handling facilities. Particles in leachate water exhibited similar PCB sorption properties as solid waste collected on site, with waste-water partitioning coefficients ranging from 105 to 107. I-PCB7 in air samples collected at the sites were mostly in the gas phase (100–24000 pg/m3), compared to those associated with particles (9–1900 pg/m3). In contrast brominated flame retardants (BFRs) in the same samples were predominantly found associated with particles (e.g. sum of 10 brominated diethyl ethers, ΣBDE10, associated with particles 77–194,000 pg/m3) compared to the gas phase (ΣBDE10 6–473 pg/m3). Measured gas-phase I-PCB7 concentrations are less than predicted, assuming waste-air partitioning in equilibrium with predominant waste on site. However, the gas-particle partitioning behavior of PCBs and BFRs could be predicted using an established partitioning model for ambient aerosols. PCB emissions from Norwegian waste handling facilities occurred primarily in the form of atmospheric vapor or leachate particles.
2020
2020
Risk governance of emerging technologies demonstrated in terms of its applicability to nanomaterials
Nanotechnologies have reached maturity and market penetration that require nano‐specific changes in legislation and harmonization among legislation domains, such as the amendments to REACH for nanomaterials (NMs) which came into force in 2020. Thus, an assessment of the components and regulatory boundaries of NMs risk governance is timely, alongside related methods and tools, as part of the global efforts to optimise nanosafety and integrate it into product design processes, via Safe(r)‐by‐Design (SbD) concepts. This paper provides an overview of the state‐of‐the‐art regarding risk governance of NMs and lays out the theoretical basis for the development and implementation of an effective, trustworthy and transparent risk governance framework for NMs. The proposed framework enables continuous integration of the evolving state of the science, leverages best practice from contiguous disciplines and facilitates responsive re‐thinking of nanosafety governance to meet future needs. To achieve and operationalise such framework, a science‐based Risk Governance Council (RGC) for NMs is being developed. The framework will provide a toolkit for independent NMs' risk governance and integrates needs and views of stakeholders. An extension of this framework to relevant advanced materials and emerging technologies is also envisaged, in view of future foundations of risk research in Europe and globally.
2020
2020
Combining information from several channels of the Norwegian Institute for Air Research (NILU-UV) irradiance meter, one may determine the total ozone column (TOC) amount. A NILU-UV instrument has been deployed and operated on two locations at Troll research station in Jutulsessen, Queen Maud Land, Antarctica, for several years. The method used to determine the TOC amount is presented, and the derived TOC values are compared with those obtained from the Ozone Monitoring Instrument (OMI) located on NASA’s AURA satellite. The findings show that the NILU-UV TOC amounts correlate well with the results of the OMI and that the NILU-UV instruments are suitable for monitoring the long-term change and development of the ozone hole. Because of the large footprint of OMI, NILU-UV is a more suitable instrument for local measurements.
2020
Organic contaminants (polycyclic aromatic hydrocarbons (PAHs), polybrominated diphenyl ethers (PBDEs), polychlorinated biphenyls (PCBs), and chlorinated paraffins (CPs)) and heavy metals and metalloids (Ag, Cd, Co, Cr, Cu, Hg, Ni, Pb, Sb, Zn) were analysed in surface soil samples from the Agbogbloshie e-waste processing and dumping site in Accra (Ghana). In order to identify which of the pollutants are likely to be linked specifically to handling of e-waste, samples were also collected from the Kingtom general waste site in Freetown (Sierra Leone). The results were compared using principal component analyses (PCA). PBDE congeners found in technical octa-BDE mixtures, highly chlorinated PCBs and several heavy metals (Cu, Pb, Ni, Cd, Ag and Hg) showed elevated concentrations in the soils that are likely due to contamination by e-waste. PCAs associated those compounds with pyrogenic PAHs, suggesting that burning of e-waste, a common practice to isolate valuable metals, may cause this contamination. Moreover, other contamination pathways, especially incorporation of waste fragments into the soil, also appeared to play an important role in determining concentrations of some of the pollutants in the soil. Concentrations of several of these compounds were extremely high (especially PBDEs, heavy metals and SCCPs) and in some cases exceeded action guideline levels for soil. This indicates that exposure to these contaminants via the soil alone is potentially harmful to the recyclers and their families living on waste sites. Many organic contaminants and other exposure pathways such as inhalation are not yet included in such guidelines but may also be significant, given that deposition from the air following waste burning was identified as a major pollutant source.
2020
Atmospheric inversions have been used for the past two decades to derive large-scale constraints on the sources and sinks of CO2 into the atmosphere. The development of dense in situ surface observation networks, such as ICOS in Europe, enables in theory inversions at a resolution close to the country scale in Europe. This has led to the development of many regional inversion systems capable of assimilating these high-resolution data, in Europe and elsewhere. The EUROCOM (European atmospheric transport inversion comparison) project is a collaboration between seven European research institutes, which aims at producing a collective assessment of the net carbon flux between the terrestrial ecosystems and the atmosphere in Europe for the period 2006–2015. It aims in particular at investigating the capacity of the inversions to deliver consistent flux estimates from the country scale up to the continental scale.
The project participants were provided with a common database of in situ-observed CO2 concentrations (including the observation sites that are now part of the ICOS network) and were tasked with providing their best estimate of the net terrestrial carbon flux for that period, and for a large domain covering the entire European Union. The inversion systems differ by the transport model, the inversion approach, and the choice of observation and prior constraints, enabling us to widely explore the space of uncertainties.
This paper describes the intercomparison protocol and the participating systems, and it presents the first results from a reference set of inversions, at the continental scale and in four large regions. At the continental scale, the regional inversions support the assumption that European ecosystems are a relatively small sink (−0.21±0.2
Pg C yr−1). We find that the convergence of the regional inversions at this scale is not better than that obtained in state-of-the-art global inversions. However, more robust results are obtained for sub-regions within Europe, and in these areas with dense observational coverage, the objective of delivering robust country-scale flux estimates appears achievable in the near future.
2020
2020
2020
Monitoring of greenhouse gases and aerosols at Svalbard and Birkenes in 2019. Annual report.
The report summarizes the activities and results of the greenhouse gas monitoring at the Zeppelin Observatory, situated on Svalbard in Arctic Norway, during the period 2001-2019, and the greenhouse gas monitoring and aerosol observations from Birkenes for 2009-2019.
NILU
2020
Transboundary particulate matter, photo-oxidants, acidifying and eutrophying components
Meteorologisk institutt
2020