Found 9746 publications. Showing page 382 of 390:
The extreme persistence and environmental mobility of per- and polyfluoroalkyl substances (PFAS) make their presence ubiquitous in the marine environment. Target analysis of 20 most common PFAS revealed the presence of nine perfluoroalkyl acids at low levels in surface sediments from five Norwegian marine areas covering the vast region from the eastern North Sea in the south to the Arctic Ocean north of Svalbard in the north. After correcting for sediment characteristics, no substantial difference in the sum of the nine PFAS (Σ9PFAS) between the five areas was found. Among separate compounds, PFOS, PFOA and PFNA dominate sample composition. Only two compounds, PFOS and PFUnDA, showed a statistically significant difference for one of the areas, the levels of these compounds being somewhat higher in the southernmost area than in the other areas. This may be due to local inputs in the fjords in this area. Open-sea and coastal sediments of the North-east Atlantic outside of locations with significant local sources seem to share a common, anthropogenic “PFAS background”, which may be part of a larger, global pattern.
Elsevier
2024
Testing ethical impact assessment for nano risk governance
Risk governance of nanomaterials and nanotechnologies has been traditionally mainly limited to risk assessment, risk management and life cycle assessment. Recent approaches have experimented with widening the scope and including economic, social, and ethical aspects. This paper reports on tests and stakeholder feedback on fine-tuning the use of ethical impact assessment guidelines (RiskGONE D3.6) and online tools adapting the CEN Workshop Agreement part 2 CWA 17145-2:2017 (E)) to support risk governance of nanomaterials, in the RiskGONE project. The EIA guidelines and tools are intended to be used as one module in a multicriteria decision support framework for risk governance of nanomaterials, but may also be used for a stand-alone ethical impact assessment.
Nanomaterials are new forms of materials with structures at sizes between 1 and 100 nanometres (a millionth of a millimetre). They can be particles, tubes, platelets or other shaped structures. Nanomaterials can be applied in many different products, ranging from medicine to solar panels. Researchers, governments and stakeholders have been concerned with potential risks for human health and the environment for decades. Also, how nanomaterials behave during the production, use and waste processing of the products they are included in has been investigated in Life Cycle Analysis. However, ethical issues which may be raised by the use of nanomaterials in those products are usually not investigated. In this article, the procedure for an ethical impact assessment described in the CEN Workshop Agreement CWA 17145-@:2017 (E) is adapted to nanomaterials. Users who want to perform this assessment are guided through the procedure by online tools. The guidelines and tools were tested on several case studies and discussed with stakeholders, who commented on the criteria which should be used and on who could use the tools. This results in recommendations for improving the guidelines and online tools.
2024
Monitoring of environmental contaminants in freshwater food webs (MILFERSK), 2023
Norsk institutt for vannforskning
2024
The FAIR principles as a key enabler to operationalize safe and sustainable by design approaches
Safe and sustainable development of chemicals, (advanced) materials, and products is at the heart of achieving a healthy future environment in line with the European Green Deal and the Chemicals Strategy for Sustainability. Recently, the Joint Research Center (JRC) of the European Commission (EC) developed the safe and sustainable by design (SSbD) framework for definition of criteria and evaluation procedure proposed to be established in Research and Innovation (R&I) activities. The framework aims to support the design of chemicals, materials and products that provide desirable functions (or services), while simultaneously minimizing the risk for harmful impacts to human health and the environment. While many industrial sectors already consider such aspects during R&I, the framework aims to harmonize safety and sustainability assessment across diverse sectors and innovation strategies to meet the mentioned overarching policy goals. A cornerstone to successfully implement and operationalize the SSbD framework lies in the availability of high-quality data and tools, and their interoperability, aspects which also play a key role in ensuring transparency and thereby trust in the assessment outcomes. Availability of data and tools depend on their machine-actionability in terms of findability, accessibility, interoperability, and reusability, in line with the FAIR principles. The principles were developed in order to harmonize digitalization across all data domains, supporting unanticipated data-driven “seamless” integration of information and generation of new knowledge. Here we discuss the essentiality of FAIR data and tools to operationalize SSbD providing views and examples of activities within the European Partnership for the Assessment of Risks from Chemicals (PARC). The discussion covers five areas previously brought up in relation to the SSbD framework, and which are highly dependent on implementation of the FAIR principles; (i) digitalization to leverage innovation towards a green transition; (ii) existing data sources and their interoperability; (iii) navigating SSbD with data from new scientific developments (iv) transparency and trust through automated assessment of data quality and uncertainty; and (v) “seamless” integration of SSbD tools.
Royal Society of Chemistry (RSC)
2024
Large stocks of soil carbon (C) and nitrogen (N) in northern permafrost soils are vulnerable to remobilization under climate change. However, there are large uncertainties in present-day greenhouse gas (GHG) budgets. We compare bottom-up (data-driven upscaling and process-based models) and top-down (atmospheric inversion models) budgets of carbon dioxide (CO2), methane (CH4) and nitrous oxide (N2O) as well as lateral fluxes of C and N across the region over 2000–2020. Bottom-up approaches estimate higher land-to-atmosphere fluxes for all GHGs. Both bottom-up and top-down approaches show a sink of CO2 in natural ecosystems (bottom-up: −29 (−709, 455), top-down: −587 (−862, −312) Tg CO2-C yr−1) and sources of CH4 (bottom-up: 38 (22, 53), top-down: 15 (11, 18) Tg CH4-C yr−1) and N2O (bottom-up: 0.7 (0.1, 1.3), top-down: 0.09 (−0.19, 0.37) Tg N2O-N yr−1). The combined global warming potential of all three gases (GWP-100) cannot be distinguished from neutral. Over shorter timescales (GWP-20), the region is a net GHG source because CH4 dominates the total forcing. The net CO2 sink in Boreal forests and wetlands is largely offset by fires and inland water CO2 emissions as well as CH4 emissions from wetlands and inland waters, with a smaller contribution from N2O emissions. Priorities for future research include the representation of inland waters in process-based models and the compilation of process-model ensembles for CH4 and N2O. Discrepancies between bottom-up and top-down methods call for analyses of how prior flux ensembles impact inversion budgets, more and well-distributed in situ GHG measurements and improved resolution in upscaling techniques.
American Geophysical Union (AGU)
2024
We investigate the concentration fluctuations of passive scalar plumes emitted from small, localised (point-like) steady sources in a neutrally stratified turbulent boundary layer over a rough wall. The study utilises high-resolution large-eddy simulations for sources of varying sizes and heights. The numerical results, which show good agreement with wind-tunnel studies, are used to estimate statistical indicators of the concentration field, including spectra and moments up to the fourth order. These allow us to elucidate the mechanisms responsible for the production, transport and dissipation of concentration fluctuations, with a focus on the very near field, where the skewness is found to have negative values – an aspect not previously highlighted. The gamma probability density function is confirmed to be a robust model for the one-point concentration at sufficiently large distances from the source. However, for ground-level releases in a well-defined area around the plume centreline, the Gaussian distribution is found to be a better statistical model. As recently demonstrated by laboratory results, for elevated releases, the peak and shape of the pre-multiplied scalar spectra are confirmed to be independent of the crosswind location for a given downwind distance. Using a stochastic model and theoretical arguments, we demonstrate that this is due to the concentration spectra being directly shaped by the transverse and vertical velocity components governing the meandering of the plume. Finally, we investigate the intermittency factor, i.e. the probability of non-zero concentration, and analyse its variability depending on the thresholds adopted for its definition.
Cambridge University Press
2024
NILU og Transportøkonomisk institutt (TØI) har på oppdrag fra Miljødirektoratet videreutviklet modellen NERVE («Norwegian Emissions from Road Vehicle Exhaust») for beregning av klimagassutslipp fra veitrafikken i norske kommuner. NERVE-modellen anvender de mest detaljerte datasettene for bilpark, utslippsfaktorer, trafikk og veier for spesifikke lokale forhold. Datasettene er kombinert i en datastruktur som gjør at resultat kan aggregeres på et lite eller et stort geografisk område. NERVE kan således betegnes som en «bottom-up»-utslippsmodell, fordi den er bygget opp «nedenfra» fra detaljerte datakilder. Denne rapporten presenterer metodikken og antagelsene bak beregningene med NERVE, og sammenligner resultat aggregert på nasjonalt nivå med annen tilgjengelig nasjonal statistikk.
NILU
2024
2024
2024
Design of multi-luminescent silica-based nanoparticles for the detection of liquid organic compounds
Tracer testing in reservoir formations is utilised to determine residual oil saturation as part of optimum hydrocarbon production. Here, we present a novel detection method of liquid organic compounds by monodisperse SiO2 nanoparticles (NPs) containing two luminophores, a EuIII:EDTA complex and a newly synthesised fluorophore based on the organic boron-dipyrromethene (BODIPY)-moiety. The particles exhibited stable EuIII PL emission intensity with a long lifetime in aqueous dispersion. The fluorescence of the BODIPY was also preserved in the aqueous environment. The ratiometric PL detection technique was demonstrated by using toluene and 1-octanol as model compounds of crude oil. The optimal synthesis conditions were found to give NPs with a diameter of ~100 nm, which is suitable for transport through porous oil reservoir structures. The cytotoxicity of the NPs was confirmed to be very low for human lung cell and fish cell lines. These findings demonstrate the potential of the NPs to replace the hazardous chemicals used to estimate the residual oil saturation. Moreover, the ratiometric PL detection technique is anticipated to be of benefit in other fields, such as biotechnology, medical diagnostics, and environmental monitoring, where a reliable and safe detection of a liquid organic phase is needed.
Wiley-VCH
2024
2024
2024
The Chinese Loess Plateau (CLP) in northern China is home to one of the most prominent loess records in the world, reflecting past eolian dust activity in East Asia. However, their interpretation is hampered by ambiguity in the origin of loess-forming dust and an incomplete understanding of the circulation forcing dust accumulation. In this study, we used a novel modeling approach combining a dust emission model FLEXDUST with simulated back trajectories from FLEXPART to trace the dust back to where it was emitted. Over 21 years (1999–2019), we modeled back trajectories for fine (∼2 μm) and super-coarse (∼20 μm) dust particles at six CLP sites during the peak dust storm season from March to May. FLEXPART source-receptor relationships are combined with the dust emission inventory from FLEXDUST to create site-dependent high-resolution maps of the source contribution of deposited dust. The nearby dust emission areas were found to be the main source of dust to the CLP. Dust deposition across the CLP was found to predominantly occur via wet removal, with also some super-coarse dust from distant emission regions being wet deposited following high-level tropospheric transport. The high topography located on the downwind side of the emission area plays an essential role in forcing the emitted super-coarse dust upward. On an interannual scale, the phase of the Arctic Oscillation in the preceding winter was found to have a strong association with the spring deposition rate on the CLP, while the strength of the East Asian Winter Monsoon was less influential.
American Geophysical Union (AGU)
2024
Miljøforskernes nye reklamedingser var fulle av miljøgifter
Norges forskningsråd
2024
NILU har på oppdrag fra Multiconsult AS gjort spredningsberegninger av utslipp til luft fra fremtidig renseanlegg i Nordbykollen i Drammen, samt pumpestasjon ved Solumstrand. Det er gjort beregninger for tre utslippspunkter ved Nordbykollen, 15 moh., 45 moh. og 85 moh. og det er beregnet grad av fortynning ved ulike naboer. Vurderingen er at ved normale driftsforhold vil plasseringen 15 moh. være tilstrekkelig for å minimere risiko for lukt. Men ved spesielle værforhold som inversjon kan det oppstå situasjoner med stabil luft og dårlig fortynning med økt risiko for følbar lukt hos nærmeste naboer. For pumpestasjonen ved Solumstrand bør det velges en løsning med minimum 10-12 m skorstein og vertikal utgangshastighet 5-6 m/s for å sikre god spredning og fortynning av utslippet.
NILU
2024
Monitoring of microplastics in the Norwegian environment (MIKRONOR) 2023
The MIKRONOR monitoring program aims to establish baseline levels of microplastics in the Norwegian environment and to identify potential sources and sinks. This third MIKRONOR report focuses mainly on results from air samples, including data on tyre wear particles (TWP), as well as river and fjord surface water samples, and their correlation to rainfall and river discharge levels. Additionally, it presents data from sand samples taken from an OSPAR beach in the outer Oslofjord. The results for 2023 provide evidence of the omnipresence of microplastics in the environment. However, levels were higher near cities and populated areas, with decreasing levels further from human activities. This trend was observed in both air and surface water samples. Sand samples from the OSPAR beach in the Oslofjord showed levels of microplastics comparable to, or slightly higher than studied eabches at Svalbard. Since no other beach studies have been conducted in the MIKRONOR program, it is difficult to determine typical microplastic levels on a beach in the outer Oslofjord. Determined levels of microplastics in the beach samples were comparable to levels in marine bottom sediment at remote areas along the coast and lower than levels in sediments from the Oslofjord. Main conclusions of this report highlight the need for further research into the processes that control the levels and variations of microplastics and TWPs, such as weather conditions, river discharge, and air mass movement. Sampling of different matrices should, where possible, be conducted using similar strategies and equipment to improve the comparability of results. Additionally, the high spatial and temporal variability between samples must be considered to determine the appropriate number of analyses needed to obtain reliable results.
Norsk institutt for vannforskning og Miljødirektoratet
2024
2024
2024