Found 2698 publications. Showing page 38 of 270:
Potential environmental impact of bromoform from Asparagopsis farming in Australia
To mitigate the rumen enteric methane (CH4) produced by ruminant livestock, Asparagopsis taxiformis is proposed as an additive to ruminant feed. During the cultivation of Asparagopsis taxiformis in the sea or in terrestrially based systems, this macroalgae, like most seaweeds and phytoplankton, produces a large amount of bromoform (CHBr3), which contributes to ozone depletion once released into the atmosphere. In this study, we focus on the impact of CHBr3 on the stratospheric ozone layer resulting from potential emissions from proposed Asparagopsis cultivation in Australia. The impact is assessed by weighting the emissions of CHBr3 with its ozone depletion potential (ODP), which is traditionally defined for long-lived halocarbons but has also been applied to very short-lived substances (VSLSs). An annual yield of ∼3.5 × 104 Mg dry weight is required to meet the needs of 50 % of the beef feedlot and dairy cattle in Australia. Our study shows that the intensity and impact of CHBr3 emissions vary, depending on location and cultivation scenarios. Of the proposed locations, tropical farms near the Darwin region are associated with the largest CHBr3 ODP values. However, farming of Asparagopsis using either ocean or terrestrial cultivation systems at any of the proposed locations does not have the potential to significantly impact the ozone layer. Even if all Asparagopsis farming were performed in Darwin, the CHBr3 emitted into the atmosphere would amount to less than 0.02 % of the global ODP-weighted emissions. The impact of remaining farming scenarios is also relatively small even if the intended annual yield in Darwin is scaled by a factor of 30 to meet the global requirements, which will increase the global ODP-weighted emissions up to ∼0.5 %.
2022
Numerical Study of Non-Linear Effects for a Swept Bias Langmuir Probe
We present a numerical study disclosing non-linear effects and hysteresis loops for a swept bias Langmuir probe. A full kinetic particle in cell (PIC) model has been used to study the temporal sheath effects and the probe current. Langmuir "close to steady state" condition is required to characterize the plasma. However, during operations above frequencies normally used, capacitive and non-linear resistive effects are being unveiled. We demonstrate how ion and electron density and temperature change properties of the probe-plasma system. We also show that a swept Langmuir probe exhibits essential properties described as the "fingerprint of memristors" and how a Langmuir probe can be identified as a transversal memristor. Understanding non-linear processes might enable new ways to operate Langmuir probes with higher sampling rates and better accuracy.
2022
The miniaturized enzyme-modified comet assay for genotoxicity testing of nanomaterials
The in vitro comet assay is a widely applied method for investigating genotoxicity of chemicals including engineered nanomaterials (NMs). A big challenge in hazard assessment of NMs is possible interference between the NMs and reagents or read-out of the test assay, leading to a risk of biased results. Here, we describe both the standard alkaline version of the in vitro comet assay with 12 mini-gels per slide for detection of DNA strand breaks and the enzyme-modified version that allows detection of oxidized DNA bases by applying lesion-specific endonucleases (e.g., formamidopyrimidine DNA glycosylase or endonuclease III). We highlight critical points that need to be taken into consideration when assessing the genotoxicity of NMs, as well as basic methodological considerations, such as the importance of carrying out physicochemical characterization of the NMs and investigating uptake and cytotoxicity. Also, experimental design—including treatment conditions, cell number, cell culture, format and volume of medium on the plate—is crucial and can have an impact on the results, especially when testing NMs. Toxicity of NMs depends upon physicochemical properties that change depending on the environment. To facilitate testing of numerous NMs with distinct modifications, the higher throughput miniaturized version of the comet assay is essential.
2022
Ecologically unequal exchange arises if more developed economies ('core') shift the environmental burden of their consumption and capital accumulation to less developed economies ('periphery'/'semi-core'). Here we demonstrate that human populations in core regions can benefit from the use of products containing toxic chemicals while transferring to the periphery the risk of human and ecological exposure to emissions associated with manufacturing and waste disposal. We use a global scale substance flow analysis approach to quantify the emissions of polybrominated diphenyl ethers (PBDEs), a group of flame retardants added to consumer products, that are embodied in the trade of chemicals, products and wastes between seven world regions over the 2000–2020 time period. We find that core regions have off-loaded PBDE emissions, mostly associated with the disposal of electrical and electronic waste (e-waste), to semi-core and peripheral regions in mainland China and the Global South. In core regions this results in small emissions that mostly occur during the product use phase, whereas in peripheral regions emissions are much higher and dominated by end of life disposal. The transfer of toxic chemical emissions between core and periphery can be quantified and should be accounted for when appraising the costs and benefits of global trade relationships.
2022
Machine learning-based stocks and flows modeling of road infrastructure
This paper introduces a new method to account for the stocks and flows of road infrastructure at the national level based on material flow accounting (MFA). The proposed method closes some of the current shortcomings in road infrastructures that were identified through MFA: (1) the insufficient implementation of prospective analysis, (2) heavy use of archetypes as a way to represent road infrastructure, (3) inadequate attention to the inclusion of dissipative flows, and (4) limited coverage of the uncertainties. The proposed dynamic bottom-up MFA method was tested on the Norwegian road network to estimate and predict the material stocks and flows between 1980 and 2050. Here, a supervised machine learning model was introduced to estimate the road infrastructure instead of archetypical mapping of different roads. The dissipation of materials from the road infrastructure based on tire–pavement interaction was incorporated. Moreover, this study utilizes iterative classified and regression trees, lifetime distributions, randomized material intensities, and sensitivity analyses to quantify the uncertainties.
2022
The Arctic is warming two to three times faster than the global average, and the role of aerosols is not well constrained. Aerosol number concentrations can be very low in remote environments, rendering local cloud radiative properties highly sensitive to available aerosol. The composition and sources of the climate-relevant aerosols, affecting Arctic cloud formation and altering their microphysics, remain largely elusive due to a lack of harmonized concurrent multi-component, multi-site, and multi-season observations. Here, we present a dataset on the overall chemical composition and seasonal variability of the Arctic total particulate matter (with a size cut at 10 μm, PM10, or without any size cut) at eight observatories representing all Arctic sectors. Our holistic observational approach includes the Russian Arctic, a significant emission source area with less dedicated aerosol monitoring, and extends beyond the more traditionally studied summer period and black carbon/sulfate or fine-mode pollutants. The major airborne Arctic PM components in terms of dry mass are sea salt, secondary (non-sea-salt, nss) sulfate, and organic aerosol (OA), with minor contributions from elemental carbon (EC) and ammonium. We observe substantial spatiotemporal variability in component ratios, such as EC/OA, ammonium/nss-sulfate and OA/nss-sulfate, and fractional contributions to PM. When combined with component-specific back-trajectory analysis to identify marine or terrestrial origins, as well as the companion study by Moschos et al 2022 Nat. Geosci. focusing on OA, the composition analysis provides policy-guiding observational insights into sector-based differences in natural and anthropogenic Arctic aerosol sources. In this regard, we first reveal major source regions of inner-Arctic sea salt, biogenic sulfate, and natural organics, and highlight an underappreciated wintertime source of primary carbonaceous aerosols (EC and OA) in West Siberia, potentially associated with the oil and gas sector. The presented dataset can assist in reducing uncertainties in modelling pan-Arctic aerosol-climate interactions, as the major contributors to yearly aerosol mass can be constrained. These models can then be used to predict the future evolution of individual inner-Arctic atmospheric PM components in light of current and emerging pollution mitigation measures and improved region-specific emission inventories.
2022
Optical properties of surface aerosols at Dome C, Antarctica, in 2007–2013 and their potential source areas are presented. Scattering coefficients (σsp) were calculated from measured particle number size distributions with a Mie code and from filter samples using mass scattering efficiencies. Absorption coefficients (σap) were determined with a three-wavelength Particle Soot Absorption Photometer (PSAP) and corrected for scattering by using two different algorithms. The scattering coefficients were also compared with σsp measured with a nephelometer at the South Pole Station (SPO). The minimum σap was observed in the austral autumn and the maximum in the austral spring, similar to other Antarctic sites. The darkest aerosol, i.e., the lowest single-scattering albedo ωo≈0.91, was observed in September and October and the highest ωo≈0.99 in February and March. The uncertainty of the absorption Ångström exponent αap is high. The lowest αap monthly medians were observed in March and the highest in August–October. The equivalent black carbon (eBC) mass concentrations were compared with eBC measured at three other Antarctic sites: the SPO and two coastal sites, Neumayer and Syowa. The maximum monthly median eBC concentrations are almost the same ( ng m−3) at all these sites in October–November. This suggests that there is no significant difference in eBC concentrations between the coastal and plateau sites. The seasonal cycle of the eBC mass fraction exhibits a minimum f(eBC) ≈0.1 % in February–March and a maximum ∼4 %–5 % in August–October. Source areas were calculated using 50 d FLEXPART footprints. The highest eBC concentrations and the lowest ωo were associated with air masses coming from South America, Australia and Africa. Vertical simulations that take BC particle removal processes into account show that there would be essentially no BC particles arriving at Dome C from north of latitude 10∘ S at altitudes
2022
To understand the exposure and potential sources of emerging brominated flame retardants (EBFR) and organophosphate esters (OPEs) in marine wildlife from the Norwegian Arctic, we investigated concentrations of EBFRs in 157 tissue samples from nine species of marine vertebrates and OPEs in 34 samples from three whale species. The samples, collected from a wide range of species with contrasting areal use and diets, included blubber of blue whales, fin whales, humpback whales, white whales, killer whales, walruses and ringed seals and adipose tissue and plasma from polar bears, as well as adipose tissue from glaucous gulls. Tris(2-ethylhexyl) phosphate (TEHP) and tris(2-chloroisopropyl) phosphate (TCIPP) ranged from <0.61 to 164 and < 0.8–41 ng/g lipid weight, respectively, in blue whales and fin whales. All other EBRFs and OPEs were below the detection limit or detected only at low concentration. In addition to the baseline information on the occurrence of EBFRs and OPEs in marine wildlife from the Arctic, we provide an in-depth discussion regarding potential sources of the detected compounds. This information is important for future monitoring and management of EBFRs and OPEs.
2022
European Registry of Materials: global, unique identifiers for (undisclosed) nanomaterials
Management of nanomaterials and nanosafety data needs to operate under the FAIR (findability, accessibility, interoperability, and reusability) principles and this requires a unique, global identifier for each nanomaterial. Existing identifiers may not always be applicable or sufficient to definitively identify the specific nanomaterial used in a particular study, resulting in the use of textual descriptions in research project communications and reporting. To ensure that internal project documentation can later be linked to publicly released data and knowledge for the specific nanomaterials, or even to specific batches and variants of nanomaterials utilised in that project, a new identifier is proposed: the European Registry of Materials Identifier. We here describe the background to this new identifier, including FAIR interoperability as defined by FAIRSharing, identifiers.org, Bioregistry, and the CHEMINF ontology, and show how it complements other identifiers such as CAS numbers and the ongoing efforts to extend the InChI identifier to cover nanomaterials. We provide examples of its use in various H2020-funded nanosafety projects.
2022
Electrification of residential heating and investment in building energy efficiency are central pillars of many national strategies to reduce carbon emissions from the built environment sector. Ireland has a strong dependence on oil use for central heating and a substantial share of homes still using solid fuels. The current national strategy calls for the retrofitting of 400,000 home heating systems with heat pumps by 2030, principally replacing oil fired heating systems. Displacing natural gas, oil and solid fuel boilers with heat pumps will have a favourable impact on climate outcomes. However, the impact on air pollutant outcomes is far more favourable when solid fuels are replaced, and the positive impact on ambient air quality is much enhanced where concentrated clusters of solid-fuel use are targeted. This research spatially analyses emissions and air pollutant concentration outcomes for both targeted and non-targeted deployments of heat pumps and shows that a focused deployment of just 3% of the national heat pump target on solid-fuel homes could offer similar progress on climate goals but with a substantial impact in terms of reducing air pollution hot spots. For the Irish residential heating season (October–March), the targeted solid fuel scenario delivers average PM2.5 concentration decreases of 20–34%. This paper shows that these targeted communities are often in areas of relative deprivation, and as such, direct support for fabric retrofitting and heat pump technology installation offers the potential to simultaneously advance climate, air and just transition policy ambitions.
2022