Found 2670 publications. Showing page 39 of 267:
Common Considerations for Genotoxicity Assessment of Nanomaterials
Genotoxicity testing is performed to determine potential hazard of a chemical or agent for direct or indirect DNA interaction. Testing may be a surrogate for assessment of heritable genetic risk or carcinogenic risk. Testing of nanomaterials (NM) for hazard identification is generally understood to require a departure from normal testing procedures found in international standards and guidelines. A critique of the genotoxicity literature in Elespuru et al., 2018, reinforced evidence of problems with genotoxicity assessment of nanomaterials (NM) noted by many previously. A follow-up to the critique of problems (what is wrong) is a series of methods papers in this journal designed to provide practical information on what is appropriate (right) in the performance of genotoxicity assays altered for NM assessment. In this “Common Considerations” paper, general considerations are addressed, including NM characterization, sample preparation, dosing choice, exposure assessment (uptake) and data analysis that are applicable to any NM genotoxicity assessment. Recommended methods for specific assays are presented in a series of additional papers in this special issue of the journal devoted to toxicology methods for assessment of nanomaterials: the In vitro Micronucleus Assay, TK Mutagenicity assays, and the In vivo Comet Assay. In this context, NM are considered generally as insoluble particles or test articles in the nanometer size range that present difficulties in assessment using techniques described in standards such as OECD guidelines.
2022
Advanced in vitro models are needed to support next-generation risk assessment (NGRA), moving from hazard assessment based mainly on animal studies to the application of new alternative methods (NAMs). Advanced models must be tested for hazard assessment of nanomaterials (NMs). The aim of this study was to perform an interlaboratory trial across two laboratories to test the robustness of and optimize a 3D lung model of human epithelial A549 cells cultivated at the air–liquid interface (ALI). Potential change in sensitivity in hazard identification when adding complexity, going from monocultures to co- and tricultures, was tested by including human endothelial cells EA.hy926 and differentiated monocytes dTHP-1. All models were exposed to NM-300K in an aerosol exposure system (VITROCELL® cloud-chamber). Cyto- and genotoxicity were measured by AlamarBlue and comet assay. Cellular uptake was investigated with transmission electron microscopy. The models were characterized by confocal microscopy and barrier function tested. We demonstrated that this advanced lung model is applicable for hazard assessment of NMs. The results point to a change in sensitivity of the model by adding complexity and to the importance of detailed protocols for robustness and reproducibility of advanced in vitro models
2022
Lack of mutagenicity of TiO2 nanoparticles in vitro despite cellular and nuclear uptake
The potential genotoxicity of titanium dioxide (TiO2) nanoparticles (NPs) is a conflictive topic because both positive and negative findings have been reported. To add clarity, we have carried out a study with two cell lines (V79–4 and A549) to evaluate the effects of TiO2 NPs (NM-101), with a diameter ranging from 15 to 60 nm, at concentrations 1–75 μg/cm2. Using two different dispersion procedures, cell uptake was determined by Transmission Electron Microscopy (TEM). Mutagenicity was evaluated using the Hprt gene mutation test, while genotoxicity was determined with the comet assay, detecting both DNA breaks and oxidized DNA bases (with formamidopyrimidine glycosylase - Fpg). Cell internalization, as determined by TEM, shows TiO2 NM-101 in cytoplasmic vesicles, as well as close to and inside the nucleus. Such internalization did not depend on the state of agglomeration, nor the dispersion used. In spite of such internalization, no cytotoxicity was detected in V79–4 cells (relative growth activity and plating efficiency assays) or in A549 cells (AlamarBlue assay) after exposure lasting for 24 h. However, a significant decrease in the relative growth activity was detected at longer exposure times (48 and 72 h) and at the highest concentration 75 µg/cm2. When the modified enzyme-linked alkaline comet assay was performed on A549 cells, although no significant induction of DNA damage was detected, a positive concentration-effects relationship was observed (Spearman’s correlation = 0.9, p 0.0001). Furthermore, no significant increase of DNA oxidized purine bases was observed. When the frequency of Hprt gene mutants was determined in V79–4 cells, no increase was observed in the exposed cells, relative to the unexposed cultures. Our general conclusion is that, under our experimental conditions, TiO2 NM-101 exposure does not exert mutagenic effects despite the evidence of NP uptake by V79–4 cells.
2022
Updated trends for atmospheric mercury in the Arctic: 1995–2018
The Arctic region forms a unique environment with specific physical, chemical, and biological processes affecting mercury (Hg) cycles and limited anthropogenic Hg sources. However, historic global emissions and long range atmospheric transport has led to elevated Hg in Arctic wildlife and waterways. Continuous atmospheric Hg measurements, spanning 20 years, and increased monitoring sites has allowed a more comprehensive understanding of how Arctic atmospheric mercury is changing over time. Time-series trend analysis of TGM (Total Gaseous Mercury) in air was performed from 10 circumpolar air monitoring stations, comprising of high-Arctic, and sub-Arctic sites. GOM (gaseous oxidised mercury) and PHg (particulate bound mercury) measurements were also available at 2 high-Arctic sites. Seasonal mean TGM for sub-Arctic sites were lowest during fall ranging from 1.1 ng m−3 Hyytiälä to 1.3 ng m−3, Little Fox Lake. Mean TGM concentrations at high-Arctic sites showed the greatest variability, with highest daily means in spring ranging between 4.2 ng m−3 at Amderma and 2.4 ng m−3 at Zeppelin, largely driven by local chemistry. Annual TGM trend analysis was negative for 8 of the 10 sites. High-Arctic seasonal TGM trends saw smallest decline during summer. Fall trends ranged from −0.8% to −2.6% yr−1. Across the sub-Arctic sites spring showed the largest significant decreases, ranging between −7.7% to −0.36% yr−1, while fall generally had no significant trends. High-Arctic speciation of GOM and PHg at Alert and Zeppelin showed that the timing and composition of atmospheric mercury deposition events are shifting. Alert GOM trends are increasing throughout the year, while PHg trends decreased or not significant. Zeppelin saw the opposite, moving towards increasing PHg and decreasing GOM. Atmospheric mercury trends over the last 20 years indicate that Hg concentrations are decreasing across the Arctic, though not uniformly. This is potentially driven by environmental change, such as plant productivity and sea ice dynamics.
2022
The way Norway is spearheading electrification in the transport sector is of global interest. In this study, we used the Norwegian Emissions from Road Vehicle Exhaust (NERVE) model, a bottom-up high-resolution traffic emission model, to calculate all emissions in Norway (2009–2020) and evaluate potential co-benefit and trade-offs of policies to target climate change mitigation, air quality and socioeconomic factors. Results for municipal data with regard to traffic growth, road network influences, vehicle composition, emissions and energy consumption are presented. Light vehicle CO2 emissions per kilometer have been reduced by 22% since 2009, mainly driven by an increasing bio-fuel mixing and battery electric vehicles (BEV) share. BEVs are mostly located in and around the main cities, areas with young vehicle fleets, and strong local incentives. Beneficiaries of BEVs incentives have been a subset of the population with strong economic indicators. The incentivized growth in the share of diesel-fuelled passenger vehicles has been turned, and together with Euro6 emission standards, light vehicle NOx emissions have been halved since peaking in 2014. BEVs represent an investment in emission reductions in years to come, and current sales set Norway up for an accelerated decline in all exhaust emissions despite the continual growth in traffic.
2022
The influence of photochemistry on outdoor to indoor NO2 in some European museums
This paper reports 1 year of monthly average NO2 indoor to outdoor (I/O) concentrations measured in 10 European museums, and a simple steady-state box model that explains the annual variation. The measurements were performed in the EU FP5 project Master (EVK-CT-2002-00093). The work provides extensive documentation of the annual variation of NO2 I/O concentration ratios, with ratios above unity in the summer, in situations with no indoor emissions of NO2. The modelling included the most relevant production and removal processes of NO2 and showed that the outdoor photolysis was the probable main explanation of the annual trends in the NO2 I/O concentration ratios.
2022
Aerosol distributions have a potentially large influence on climate-relevant cloud properties but can be difficult to observe over the Arctic given pervasive cloudiness, long polar nights, data paucity over remote regions, and periodic diamond dust events that satellites can misclassify as aerosol. We compared Arctic 2008–2015 mineral dust and combustion aerosol distributions from the Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observation (CALIPSO) satellite, the Modern-Era Retrospective analysis for Research and Applications, Version 2 (MERRA-2) reanalysis products, and the FLEXible PARTicle (FLEXPART) dispersion model. Based on coincident, seasonal Atmospheric Infrared Sounder (AIRS) Arctic satellite meteorological data, diamond dust may occur up to 60 % of the time in winter, but it hardly ever occurs in summer. In its absence, MERRA-2 and FLEXPART each predict the vertical and horizontal distribution of large-scale patterns in combustion aerosols with relatively high confidence (Kendall tau rank correlation > 0.6), although a sizable amount of variability is still unaccounted for. They do the same for dust, except in conditions conducive to diamond dust formation where CALIPSO is likely misclassifying diamond dust as mineral dust and near the surface...
2022
Machine Learning-Based Digital Twin for Predictive Modeling in Wind Turbines
Wind turbines are one of the primary sources of renewable energy, which leads to a sustainable and efficient energy solution. It does not release any carbon emissions to pollute our planet. The wind farms monitoring and power generation prediction is a complex problem due to the unpredictability of wind speed. Consequently, it limits the decision power of the management team to plan the energy consumption in an effective way. Our proposed model solves this challenge by utilizing a 5G-Next Generation-Radio Access Network (5G-NG-RAN) assisted cloud-based digital twins’ framework to virtually monitor wind turbines and form a predictive model to forecast wind speed and predict the generated power. The developed model is based on Microsoft Azure digital twins infrastructure as a 5-dimensional digital twins platform. The predictive modeling is based on a deep learning approach, temporal convolution network (TCN) followed by a non-parametric k-nearest neighbor (kNN) regression. Predictive modeling has two components. First, it processes the univariate time series data of wind to predict its speed. Secondly, it estimates the power generation for each quarter of the year ranges from one week to a whole month (i.e., medium-term prediction) To evaluate the framework the experiments are performed on onshore wind turbines publicly available datasets. The obtained results confirm the applicability of the proposed framework. Furthermore, the comparative analysis with the existing classical prediction models shows that our designed approach obtained better results. The model can assist the management team to monitor the wind farms remotely as well as estimate the power generation in advance.
2022
Health impacts of PM
Residential wood combustion (RWC) is one of the largest sources of fine particles (PM2.5) in the Nordic cities. The current study aims to calculate the related health effects in four studied city areas in Sweden, Finland, Norway, and Denmark.
2022