Found 9759 publications. Showing page 282 of 391:
2018
While feathers have been successfully validated for monitoring of internal concentrations of heavy metals and legacy persistent organic pollutants (POPs), less is known about their suitability for monitoring ofemerging con- taminants (ECs). Our study presents a broad investigation ofboth legacy POPs and ECs in non-destructivematri- ces from a bird of prey. Plasma and feathers were sampled in 2015 and 2016 from 70 whitetailed eagle (Haliaeetus albicilla) nestlings from two archipelagos in Norway. Preen oil was also sampled in 2016. Samples were analysed for POPs (polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) and organochlorinated pesticides (OCPs)) and ECs (per- and polyfluoroalkyl substances (PFASs), dechlorane plus (DPs), phosphate and novel brominated flame retardants (PFRs and NBFRs)). A total of nine PCBs, three OCPs, one PBDE and one PFAS were detected in over 50% of the plasma and feather samples within each sampling year and location. Significant and positive correlationswere found between plasma, feathers and preen oil concentrations of legacy POPs and confirm the findings ofprevious research on the usefulness of these matrices for non-destructive mon- itoring. In contrast, the suitability of feathers for ECs seems to be limited. Detection frequencies (DF) of PFASs were higher in plasma (mean DF: 78%) than in feathers (mean DF: 38%). Only perfluoroundecanoic acid could be quantified in over 50% ofboth plasma and feather samples, yet their correlation was poor and not significant. The detection frequencies of PFRs, NBFRs and DPs were very low in plasma (mean DF: 1–13%), compared to feathers (meanDF: 10–57%). Thismay suggest external atmospheric deposition, rapid internal biotransformation or excretion of these compounds. Accordingly, we suggest prioritising plasma for PFASs analyses, while the sources of PFRs, NBFRs and DPs in feathers and plasma need further investigation.
Elsevier
2018
We present inverse modelling (top down) estimates of European methane (CH4) emissions for 2006–2012 based on a new quality-controlled and harmonised in situ data set from 18 European atmospheric monitoring stations. We applied an ensemble of seven inverse models and performed four inversion experiments, investigating the impact of different sets of stations and the use of a priori information on emissions.
The inverse models infer total CH4 emissions of 26.8 (20.2–29.7) Tg CH4 yr−1 (mean, 10th and 90th percentiles from all inversions) for the EU-28 for 2006–2012 from the four inversion experiments. For comparison, total anthropogenic CH4 emissions reported to UNFCCC (bottom up, based on statistical data and emissions factors) amount to only 21.3 Tg CH4 yr−1 (2006) to 18.8 Tg CH4 yr−1 (2012). A potential explanation for the higher range of top-down estimates compared to bottom-up inventories could be the contribution from natural sources, such as peatlands, wetlands, and wet soils. Based on seven different wetland inventories from the Wetland and Wetland CH4 Inter-comparison of Models Project (WETCHIMP), total wetland emissions of 4.3 (2.3–8.2) Tg CH4 yr−1 from the EU-28 are estimated. The hypothesis of significant natural emissions is supported by the finding that several inverse models yield significant seasonal cycles of derived CH4 emissions with maxima in summer, while anthropogenic CH4 emissions are assumed to have much lower seasonal variability. Taking into account the wetland emissions from the WETCHIMP ensemble, the top-down estimates are broadly consistent with the sum of anthropogenic and natural bottom-up inventories. However, the contribution of natural sources and their regional distribution remain rather uncertain.
Furthermore, we investigate potential biases in the inverse models by comparison with regular aircraft profiles at four European sites and with vertical profiles obtained during the Infrastructure for Measurement of the European Carbon Cycle (IMECC) aircraft campaign. We present a novel approach to estimate the biases in the derived emissions, based on the comparison of simulated and measured enhancements of CH4 compared to the background, integrated over the entire boundary layer and over the lower troposphere. The estimated average regional biases range between −40 and 20 % at the aircraft profile sites in France, Hungary and Poland.
2018
Observation of turbulent dispersion of artificially released SO2 puffs with UV cameras
In atmospheric tracer experiments, a substance is released into the turbulent atmospheric flow to study the dispersion parameters of the atmosphere. That can be done by observing the substance's concentration distribution downwind of the source. Past experiments have suffered from the fact that observations were only made at a few discrete locations and/or at low time resolution. The Comtessa project (Camera Observation and Modelling of 4-D Tracer Dispersion in the Atmosphere) is the first attempt at using ultraviolet (UV) camera observations to sample the three-dimensional (3-D) concentration distribution in the atmospheric boundary layer at high spatial and temporal resolution. For this, during a three-week campaign in Norway in July 2017, sulfur dioxide (SO2), a nearly passive tracer, was artificially released in continuous plumes and nearly instantaneous puffs from a 9m high tower. Column-integrated SO2 concentrations were observed with six UV SO2 cameras with sampling rates of several hertz and a spatial resolution of a few centimetres. The atmospheric flow was characterised by eddy covariance measurements of heat and momentum fluxes at the release mast and two additional towers. By measuring simultaneously with six UV cameras positioned in a half circle around the release point, we could collect a data set of spatially and temporally resolved tracer column densities from six different directions, allowing a tomographic reconstruction of the 3-D concentration field. However, due to unfavourable cloudy conditions on all measurement days and their restrictive effect on the SO2 camera technique, the presented data set is limited to case studies. In this paper, we present a feasibility study demonstrating that the turbulent dispersion parameters can be retrieved from images of artificially released puffs, although the presented data set does not allow for an in-depth analysis of the obtained parameters. The 3-D trajectories of the centre of mass of the puffs were reconstructed enabling both a direct determination of the centre of mass meandering and a scaling of the image pixel dimension to the position of the puff. The latter made it possible to retrieve the temporal evolution of the puff spread projected to the image plane. The puff spread is a direct measure of the relative dispersion process. Combining meandering and relative dispersion, the absolute dispersion could be retrieved. The turbulent dispersion in the vertical is then used to estimate the effective source size, source timescale and the Lagrangian integral time. In principle, the Richardson–Obukhov constant of relative dispersion in the inertial subrange could be also obtained, but the observation time was not sufficiently long in comparison to the source timescale to allow an observation of this dispersion range. While the feasibility of the methodology to measure turbulent dispersion could be demonstrated, a larger data set with a larger number of cloud-free puff releases and longer observation times of each puff will be recorded in future studies to give a solid estimate for the turbulent dispersion under a variety of stability conditions.
2018
2018
Målet er å belyse hvilke kvalitetskrav som bør stilles til luftkvalitetsberegninger, kart og data til ulike bruksformål slik disse er formulert i norsk regelverk, herunder Forurensningsloven, Folkehelseloven, Plan- og bygningsloven, Retningslinje for behandling av luftkvalitet i arealplanlegging (T1520) m.fl. Miljødirektoratet ønsker å sikre god, enhetlig og sammenlignbar kvalitet og praksis på utredninger av luftkvalitet og har bedt om anbefalinger i form av denne rapporten.
For å få et best mulig grunnlag for å vurdere behovet for veiledning og kvalitetskriterier for ulike anvendelser, har det vært fokus på å innhente informasjon og innspill fra ulike brukergrupper og fagmiljøer. Det er gjennomført en spørreundersøkelse og det er arrangert flere møter og åpne kommentarrunder med ulike brukergrupper og fagmiljøer. Siden eventuelle kvalitetskrav vil kunne ha betydning for konkurranse i markedet og påvirke ressursbruken både hos private aktører og myndigheter, har brukermedvirkning vært et viktig element i dette arbeidet etter ønske fra oppdragsgiver.
NILU
2018
Air quality in Ny-Ålesund. Monitoring of local air quality 2016-2017.
The concentrations of the measured components are generally low and below national limit values for the protection of human health and critical levels for the protection of vegetation.
Wind from northern sectors gave the highest average concentrations of nitrogen oxides and sulphur dioxide, which indicates the power station and the harbour as possible sources. The measurement results for CO2 show an annual variation with higher concentrations in the winter and lower in summer. Measured concentrations of CO were most likely caused by local snowmobile traffic.
NILU
2018
Zurich statement on future actions on per-and polyfluoroalkyl substances (PFASs)
Per- and polyfluoroalkyl substances (PFASs) are man-made chemicals that contain at least one perfluoroalkyl moiety, –CnF2n–. To date, over 4,000 unique PFASs have been used in technical applications and consumer products, and some of them have been detected globally in human and wildlife biomonitoring studies. Because of their extraordinary persistence, human and environmental exposure to PFASs will be a long-term source of concern. Some PFASs such as perfluorooctanoic acid (PFOA) and perfluorooctanesulfonic acid (PFOS) have been investigated extensively and thus regulated, but for many other PFASs, knowledge about their current uses and hazards is still very limited or missing entirely. To address this problem and prepare an action plan for the assessment and management of PFASs in the coming years, a group of more than 50 international scientists and regulators held a two-day workshop in November, 2017. The group identified both the respective needs of and common goals shared by the scientific and the policy communities, made recommendations for cooperative actions, and outlined how the science–policy interface regarding PFASs can be strengthened using new approaches for assessing and managing highly persistent chemicals such as PFASs.
2018
Modeling the Time-Variant Dietary Exposure of PCBs in China over the Period 1930 to 2100
This study aimed for the first time to reconstruct historical exposure profiles for PCBs to the Chinese population, by examining the combined effect of changing temporal emissions and dietary transition. A long-term (1930–2100) dynamic simulation of human exposure using realistic emission scenarios, including primary emissions, unintentional emissions, and emissions from e-waste, combined with dietary transition trends was conducted by a multimedia fate model (BETR-Global) linked to a bioaccumulation model (ACC-HUMAN). The model predicted an approximate 30-year delay of peak body burden for PCB-153 in a 30-year-old Chinese female, compared to their European counterpart. This was mainly attributed to a combination of change in diet and divergent emission patterns in China. A fish-based diet was predicted to result in up to 8 times higher body burden than a vegetable-based diet (2010–2100). During the production period, a worst-case scenario assuming only consumption of imported food from a region with more extensive production and usage of PCBs would result in up to 4 times higher body burden compared to consumption of only locally produced food. However, such differences gradually diminished after cessation of production. Therefore, emission reductions in China alone may not be sufficient to protect human health from PCB-like chemicals, particularly during the period of mass production. The results from this study illustrate that human exposure is also likely to be dictated by inflows of PCBs via the environment, waste, and food.
2018
2018
2018
2018