Found 9882 publications. Showing page 1 of 396:
Citizen-operated low-cost sensors for estimating outdoor particulate matter infiltration
Fine particulates observed indoors exhibit high variability, influenced by both indoor emission sources and the infiltration of outdoor particles through open spaces and the incomplete building insulation. This study examines the relationship between indoor and outdoor PM2.5 levels in Legionowo, Poland, using data from low-cost air quality sensors operated by citizens. The indoor PM2.5 was lower than outdoor levels (median PM2.5: 1.9–17.3 μg m–3 indoors and 6.7–27.9 μg m–3 outdoors), with occasional peaks attributed to potential indoor emission sources. Statistical analysis identified emission events—particularly during cooking and household-heating periods—occurring more frequently from October to April. During this period, nearly 17% of indoor PM2.5 measurements were attributed to indoor emission sources after 18:00 LT, representing a 7% increase compared to the May–September period. In the absence of indoor sources, outdoor particles accounted for 29% to 75% of indoor concentrations, highlighting the significance of infiltration. This research emphasizes how citizen-generated data using low-cost sensors, after post-processing, can provide decision-ready information as for example outdoor particles’ infiltration factors for each building. The knowledge of the infiltration factor enables the determination of the contribution of indoor and outdoor sources to each resident’s exposure to airborne PM. This information can help decision-makers in devising interventions such as prioritizing indoor ventilation, reducing indoor activities resulting in increased exposure, and addressing outdoor pollution sources.
Springer
2025
Unprecedented shifts in aerosol pollution sources in China under a decade of clean air actions
China is a major hotspot of black carbon (BC) emissions, contributing to climate warming and risk to public health. Here, our dual-isotope-constrained observations indicate stringent air pollution controls have drastically reduced coal-burning in North China over the past decade, marking a transition to a “post-coal” era compared to earlier 2012–2014. However, biomass-burning fraction (fbb) for north/central/east winter hazes has doubled from earlier (north/east) ~20%, with significantly higher fbb during polluted winters. Comparisons between observation and transport modelling show good alignment in BC concentrations but substantial discrepancies in source attribution (i.e., fbb). Leveraging radiocarbon measurements, advanced atmospheric modelling, and a Bayesian approach, our study identifies biases stemming from misallocated residential fuel types in emission inventories. These findings underscore the untapped potential to mitigate BC emissions by targeting rural biomass burning, while providing critical insights into BC source evolution to refine emission inventories and formulate effective air quality policies for China and other nations facing severe air pollution.
Springer Nature
2025
The influence of aerosols on the Arctic system remains associated with significant uncertainties, particularly concerning black carbon (BC). The polar aerosol station “Island Bely” (IBS), located in the Western Siberian Arctic, was established to enhance aerosol monitoring. Continuous measurements from 2019 to 2022 revealed the long-term effects of light-absorbing carbon. During the cold period, the annual average light-absorption coefficient was 0.7 ± 0.7 Mm−1, decreasing by 2–3 times during the warm period. The interannual mean showed a peak in February (0.9 ± 0.8 Mm−1) then 10 times the lower minimum in June and exhibited high variability in August (0.7 ± 2.2 Mm−1). An increase of up to 1.5 at shorter wavelengths from April to September suggests contribution from brown carbon (BrC). The annual mean equivalent black carbon (eBC) demonstrated considerable interannual variability, with the lowest in 2020 (24 ± 29 ng m−3). Significant difference was observed between Arctic haze and Siberian wildfire periods, with record-high pollution levels in February 2022 (110 ± 70 ng m−3) and August 2021 (83 ± 249 ng m−3). Anthropogenic BC contributed 83 % to the total for the entire study period, and gas flaring, domestic combustion, transportation, and industrial emissions dominated. During the cold season, > 90 % of surface BC was attributed to anthropogenic sources, mainly gas flaring. In contrast, during the warm period, Siberian wildfires contributed to BC concentrations by 48 %. In August 2021, intense smoke from Yakutian wildfires was transported at high altitudes during the region's worst fire season in 40 years.
2025
2025
Monitoring of long-range transported air pollutants in Norway. Annual Report 2024
This report presents results from the monitoring of atmospheric composition and deposition of air pollution in 2024, and focuses on main components in air and precipitation, particulate and gaseous phase of inorganic constituents, particulate carbonaceous matter, ground level ozone and particulate matter.
NILU
2025
2025
2025
Wood building materials can be a source of volatile organic compounds (VOCs) in the indoor environment and increasing focus is put on classification and regulation of the use of wood building materials in Europe. The main wood related VOCs such as monoterpenes rarely pose adverse health effects for humans, but as analytical procedures become more sensitive new hazardous VOCs are detected in low concentration. There is a need for comprehensive identification of VOCs emitting from different wood building materials for indoor use. This study performed a first semi-quantitative non-target and suspect screening of VOC emissions from three important wood-based building materials in Europe. Air samples collected from emission chambers were analyzed using comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry and resulting mass spectra were classified into confidence groups. A total of 84, 133 and 197 compounds were found to emit from cross-laminated timber, untreated spruce panel and untreated pine panel, respectively. Pine panel was found to emit a higher number of VOCs as well as higher concentrations of most VOCs compared to the spruce building materials. Several new VOCs were detected in the emission profile of pine and spruce. However, they were mostly structurally similar to previously reported wood VOCs. Two compounds of concern emitting from all three wood building materials were furfural and (E)-2-octenal, as these have been classified as group 2 carcinogen and potent eye irritant, respectively.
Elsevier
2025
Røyk fra skogbranner i Canada skaper dårlig luftkvalitet i flere europeiske byer
Norges forskningsråd
2025
Slik blir sommerværet i Europa, ifølge det lange langtidsvarselet
Norges forskningsråd
2025
Little is known about the exposure of aquatic biota to tire and road wear particles (TRWP) washed away from roads. Mussels were exposed for 7 days to model TRWP (m-TRWP), produced by milling tire tread particles with pure sand, and analyzed for 21 tire-related compounds by liquid chromatography-high resolution-mass spectrometry (LC-HRMS). Upon exposure to 0.5 g/L of m-TRWP, 15 compounds were determined from 944 μg/kg wet weight (diphenylguanidine, DPG) over 18 μg/kg for an oxidation product of N-(1,3-dimethylbutyl)-N′-phenyl-p-phenylenediamine (6-PPDQ) to 0.6 μg/kg (4-hydroxydiphenyl amine). Transfer into mussels was highest for PTPD, DTPD and 6-PPDQ and orders of magnitude lower for 6-PPD. During 7 days depuration the concentration of all determined chemicals decreased to remaining concentrations between ~50 % (PTPD, DTPD) and 6 % (6-PPD). Suspect and non-target screening found 37 additional transformation products (TPs) of tire additives, many of which did not decrease in concentration during depuration, among them ten likely TPs of DPG, two of 6-PPD and PTPD and two of 1,2-dihydro-2,2,4-trimethylquinoline. A wide variety of chemicals is taken up by mussels upon exposure to m-TRWP and a wide range of TPs is formed, enabling the differentiation of biomarkers of exposure to TRWP and biomarkers of exposure to tire-associated chemicals.
Elsevier
2025
Stochastic and deterministic processes in Asymmetric Tsetlin Machine
This paper introduces a new approach to enhance the decision-making capabilities of the Tsetlin Machine (TM) through the Stochastic Point Location (SPL) algorithm and the Asymmetric Steps technique. We incorporate stochasticity and asymmetry into the TM's process, along with a decaying normal distribution function that improves adaptability as it converges toward zero over time. We present two methods: the Asymmetric Probabilistic Tsetlin (APT) Machine, influenced by random events, and the Asymmetric Tsetlin (AT) Machine, which transitions from probabilistic to deterministic states. We evaluate these methods against traditional machine learning algorithms and classical Tsetlin (CT) machines across various benchmark datasets. Both AT and APT demonstrate competitive performance, with the AT model notably excelling, especially in complex datasets.
Frontiers Media S.A.
2025