Found 9985 publications. Showing page 71 of 400:
The report provides interim 2020 maps for PM10 annual average, NO2 annual average and the ozone indicator SOMO35. The maps have been produced based on non-validated Up-To-Date data reported to the AQ e-reporting database (data flow E2a), the CAMS Ensemble Forecast modelling data and other supplementary data including air quality data reported to EMEP. In addition to concentration maps, the inter-annual differences between the years 2019 and 2020 are presented (using the 2019 regular and the 2020 interim maps), as well as European exposure estimates based on the interim maps. The contribution of lockdown measures connected with the Covid-19 pandemic on the change of air pollutant concentrations during the exceptional year 2020 is briefly discussed. The decrease in road transport, aviation and international shipping intensity during the lockdown resulted in a reduction of the NOx emission, mainly in large cities and urbanized areas. Compared to 2019, a general decrease in NO2 annual average concentrations is shown for 2020, as well as a decrease in values of the ozone indicator SOMO35, apart from areas with a steep NO2 decrease. Due to the chemical processes, the decrease in NOX resulted in an ozone increase in these areas. The contribution of lockdown measures on the change of PM10 concentrations is quite complex. On the one hand, there was a decrease in emissions of suspended particles and their precursors due to decrease in transport. On the other hand, higher intensity of residential heating likely led to higher emissions of both suspended particles and their precursors.
ETC/ATNI
2021
Benzo(a)pyrene (BaP) annual mapping. Evaluation of its potential regular updating.
The report examines the potential regular production of benzo(a)pyrene (BaP) maps at the European scale in line with the operational production of other air quality maps. Stations measuring BaP are relatively scarce at the European scale, so in order to extend the spatial coverage, so-called pseudo station data have been calculated and used together with the actual BaP measurement data. These pseudo station data are derived from PM2.5 or PM10 measurements in locations with no BaP observations.
ETC/ATNI
2021
Observational studies suggest that part of the North Atlantic Oscillation (NAO) variability may be attributed to the spectral ultra-violet (UV) irradiance variations associated to the 11-year solar cycle. The observed maximum surface pressure response in the North Atlantic occurs 2–4 years after solar maximum, and some model studies have identified that atmosphere–ocean feedbacks explain the multi-year lag. Alternatively, medium-to-high energy electron (MEE) precipitation, which peaks in the declining phase of the solar cycle, has been suggested as a potential cause of this lag. We use a coupled (ocean–atmosphere) climate prediction model and a state-of-the-art MEE forcing to explore the respective roles of irradiance and MEE precipitation on the NAO variability. Three decadal ensemble experiments were conducted over solar cycle 23 in an idealized setting. We found a weak ensemble-mean positive NAO response to the irradiance. The simulated signal-to-noise ratio remained very small, indicating the predominance of internal NAO variability. The lack of multi-annual lag in the NAO response was likely due to lagged solar signals imprinted in temperatures below the oceanic mixed-layer re-emerging equatorward of the oceanic frontal zones, which anchor ocean–atmosphere feedbacks. While there is a clear, yet weak, signature from UV irradiance in the atmosphere and upper ocean over the North Atlantic, enhanced MEE precipitation on the other hand does not lead to any systematic changes in the stratospheric circulation, despite its marked chemical signatures.
2021
On behalf of Aluminiumindustriens Miljøsekretariat (AMS), NILU – Norwegian Institute for Air Research has conducted a sampling campaign in the surroundings of the Hydro Sunndal aluminium smelter in order to update the knowledge on air quality around the smelter today. Samples were taken in summer 2019 and analysed for PM2.5, PM10, metals (Pb, Cd, Cr, Ni, As, Al, V, Ga, Sb, Bi), particle-bound PAHs, SO2, particle-bound and gaseous fluorides. As a consequence of reduced emissions compared to earlier measurements, the ambient concentrations of PM10, Cr, Pb, BaP (for PAHs), SO2 and fluorides were strongly reduced. All measured compounds had concentrations below limit values and recommended
guideline values.
NILU
2021
This report provides a summary of the quality analysis of the EU Member States’ submission under 18 (1) (b) of the Regulation on the Governance of the Energy Union and Climate Action (EU) 2018/1999 conducted in 2021. Under this obligation EU Member States have to submit updated GHG projections and related information biennially. The reported information undergoes several phases of QA/QC checks consisting of checks on timeliness, accuracy, completeness, consistency and comparability. Details on the underlying QA/QC procedure are described in ETC/CME Eionet Report 7/2021.
ETC/CME
2021
2021
Reviews and syntheses: Arctic fire regimes and emissions in the 21st century
In recent years, the pan-Arctic region has experienced increasingly extreme fire seasons. Fires in the northern high latitudes are driven by current and future climate change, lightning, fuel conditions, and human activity. In this context, conceptualizing and parameterizing current and future Arctic fire regimes will be important for fire and land management as well as understanding current and predicting future fire emissions. The objectives of this review were driven by policy questions identified by the Arctic Monitoring and Assessment Programme (AMAP) Working Group and posed to its Expert Group on Short-Lived Climate Forcers. This review synthesizes current understanding of the changing Arctic and boreal fire regimes, particularly as fire activity and its response to future climate change in the pan-Arctic have consequences for Arctic Council states aiming to mitigate and adapt to climate change in the north. The conclusions from our synthesis are the following. (1) Current and future Arctic fires, and the adjacent boreal region, are driven by natural (i.e. lightning) and human-caused ignition sources, including fires caused by timber and energy extraction, prescribed burning for landscape management, and tourism activities. Little is published in the scientific literature about cultural burning by Indigenous populations across the pan-Arctic, and questions remain on the source of ignitions above 70∘ N in Arctic Russia. (2) Climate change is expected to make Arctic fires more likely by increasing the likelihood of extreme fire weather, increased lightning activity, and drier vegetative and ground fuel conditions. (3) To some extent, shifting agricultural land use and forest transitions from forest–steppe to steppe, tundra to taiga, and coniferous to deciduous in a warmer climate may increase and decrease open biomass burning, depending on land use in addition to climate-driven biome shifts. However, at the country and landscape scales, these relationships are not well established. (4) Current black carbon and PM2.5 emissions from wildfires above 50 and 65∘ N are larger than emissions from the anthropogenic sectors of residential combustion, transportation, and flaring. Wildfire emissions have increased from 2010 to 2020, particularly above 60∘ N, with 56 % of black carbon emissions above 65∘ N in 2020 attributed to open biomass burning – indicating how extreme the 2020 wildfire season was and how severe future Arctic wildfire seasons can potentially be. (5) What works in the boreal zones to prevent and fight wildfires may not work in the Arctic. Fire management will need to adapt to a changing climate, economic development, the Indigenous and local communities, and fragile northern ecosystems, including permafrost and peatlands. (6) Factors contributing to the uncertainty of predicting and quantifying future Arctic fire regimes include underestimation of Arctic fires by satellite systems, lack of agreement between Earth observations and official statistics, and still needed refinements of location, conditions, and previous fire return intervals on peat and permafrost landscapes. This review highlights that much research is needed in order to understand the local and regional impacts of the changing Arctic fire regime on emissions and the global climate, ecosystems, and pan-Arctic communities.
2021
Emissions of Tetrafluoromethane (CF4) and Hexafluoroethane (C2F6) From East Asia: 2008 to 2019
The perfluorocarbons (PFCs), tetrafluoromethane (CF4) and hexafluoroethane (C2F6), are potent greenhouse gases with very long atmospheric lifetimes. They are emitted almost entirely from industrial sources, including the aluminum and rare earth metal smelting industries that emit them as by-products, and the semiconductor and flat panel display manufacturing industries that use them and vent unutilized amounts to the atmosphere. Despite extensive industrial efforts to quantify and curb these emissions, “top-down” PFC emission estimates derived from atmospheric measurements continue to rise and are significantly greater than reported process- and inventory-based “bottom-up” emissions. In this study, we estimate emissions of CF4 and C2F6 from East Asia, where PFC emitting industries are heavily concentrated, using a top-down approach (a Bayesian inversion) with high-frequency atmospheric measurements at Gosan (Jeju Island, South Korea) for 2008–2019. We also compile and analyze the available bottom-up CF4 and C2F6 emissions in East Asia from industrial and government reports. Our results suggest that the observed increases in global PFC emissions since 2015 are driven primarily by China's aluminum industry, with significant contributions from Japan's and Korea's semiconductor industry. Our analysis suggests that Chinese emissions occur predominantly from the aluminum industry, although their emissions per production ratio may be improving. Our results for Japan and Korea find significant discrepancies between top-down and bottom-up emissions estimates, suggesting that the effectiveness of emission reduction systems (abatement) used in their semiconductor industries may be overestimated. Overall, our top-down results for East Asia contribute significantly to reducing the gap in the global PFC emission budgets.
2021
2021
Moving forward in microplastic research: A Norwegian perspective
Given the increasing attention on the occurrence of microplastics in the environment, and the potential envi-ronmental threats they pose, there is a need for researchers to move quickly from basic understanding to applied science that supports decision makers in finding feasible mitigation measures and solutions. At the same time, they must provide sufficient, accurate and clear information to the media, public and other relevant groups (e.g., NGOs). Key requirements include systematic and coordinated research efforts to enable evidence-based decision making and to develop efficient policy measures on all scales (national, regional and global). To achieve this, collaboration between key actors is essential and should include researchers from multiple disciplines, policy-makers, authorities, civil and industry organizations, and the public. This further requires clear and informative communication processes, and open and continuous dialogues between all actors. Cross-discipline dialogues between researchers should focus on scientific quality and harmonization, defining and accurately communi-cating the state of knowledge, and prioritization of topics that are critical for both research and policy, with the common goal to establish and update action plans for holistic benefit. In Norway, cross-sectoral collaboration has been fundamental in supporting the national strategy to address plastic pollution. Researchers, stakeholders and the environmental authorities have come together to exchange knowledge, identify knowledge gaps, and set targeted and feasible measures to tackle one of the most challenging aspects of plastic pollution: microplastic. In this article, we present a Norwegian perspective on the state of knowledge on microplastic research efforts. Norway’s involvement in international efforts to combat plastic pollution aims at serving as an example of how key actors can collaborate synergistically to share knowledge, address shortcomings, and outline ways forward to address environmental challenges.
2021
The Community Inversion Framework v1.0: a unified system for atmospheric inversion studies
Atmospheric inversion approaches are expected to play a critical role in future observation-based monitoring systems for surface fluxes of greenhouse gases (GHGs), pollutants and other trace gases. In the past decade, the research community has developed various inversion software, mainly using variational or ensemble Bayesian optimization methods, with various assumptions on uncertainty structures and prior information and with various atmospheric chemistry–transport models. Each of them can assimilate some or all of the available observation streams for its domain area of interest: flask samples, in situ measurements or satellite observations. Although referenced in peer-reviewed publications and usually accessible across the research community, most systems are not at the level of transparency, flexibility and accessibility needed to provide the scientific community and policy makers with a comprehensive and robust view of the uncertainties associated with the inverse estimation of GHG and reactive species fluxes. Furthermore, their development, usually carried out by individual research institutes, may in the future not keep pace with the increasing scientific needs and technical possibilities. We present here the Community Inversion Framework (CIF) to help rationalize development efforts and leverage the strengths of individual inversion systems into a comprehensive framework. The CIF is primarily a programming protocol to allow various inversion bricks to be exchanged among researchers. In practice, the ensemble of bricks makes a flexible, transparent and open-source Python-based tool to estimate the fluxes of various GHGs and reactive species both at the global and regional scales. It will allow for running different atmospheric transport models, different observation streams and different data assimilation approaches. This adaptability will allow for a comprehensive assessment of uncertainty in a fully consistent framework. We present here the main structure and functionalities of the system, and we demonstrate how it operates in a simple academic case.
2021
2021
Potential use of CAMS modelling results in air quality mapping under ETC/ATNI
ir quality European-wide annual maps based on the Regression – Interpolation – Merging Mapping (RIMM) data fusion methodology have been regularly produced, using the Air Quality e-Reporting validated (E1a) monitoring data, the EMEP modelling data and other supplementary data. In this report, we examine the use of the preliminary (E2a) monitoring data as provided up-to-date (UTD) by many European countries and as also stored in the Air Quality e-Reporting database, together with the EMEP or the Copernicus Atmospheric Monitoring Service (CAMS) modelling data in two variants (i.e. CAMS Ensemble Interim Reanalysis and CAMS Ensemble Forecast) for potential preparing of preliminary spatial maps. With respect to the availability, the CAMS Ensemble Forecast is the most useful in the potential interim mapping. Such preliminary maps could be constructed approximately one year earlier than the validated maps. Even though we have demonstrated the feasibility, the mapping performance presented in the report is influenced by the lack of the E2a data in some areas.
Next to the evaluation of potential interim maps, regular RIMM maps based on the validated E1a measurement data using three different chemical transport model outputs have been compared, i.e. using the CAMS Ensemble Forecast, the CAMS Ensemble Interim Reanalysis and the EMEP model outputs. Based on the evaluation of the results presented, it is not possible to conclude that any of the three model datasets gives definitively better results compared to the others. The results do not provide strong reasons for a potential change of the model used in the regular mapping.
In addition, the RIMM mapping results have been compared with the CAMS Ensemble Forecast and the CAMS Ensemble Interim Reanalysis outputs. The comparison shows that the data fusion RIMM method gives better results, both in the rural and urban background areas, presumably because of the higher spatial resolution, introduction of additional ancillary data in the data fusion and not fully reduced bias in some data assimilation methods used in CAMS.
ETC/ATNI
2021
2021
2021
2021
2021